Wanpipe Windows Drivers

WARNING: Netboarder Express Customers do NOT download these drivers as NBE comes with it's own version of the driver.

NBE Installation  -> http://sangoma.com/products/hardware_products/netborder_express_gateway_cards/download.html

Once there just go to the "Download" tab as shown below then download the Full or Trail version. For installation steps use the Quick Start Guide as shown below.

The Sangoma Windows Device Driver can be downloaded from this link:

Windows Driver Download -> ftp://ftp.sangoma.com/WINDOWS/AFT/wanpipe_6_0_31_0.zip.

Windows Installation PDF  -> ftp://ftp.sangoma.com/WINDOWS/AFT/INSTALL.pdf

Windows Firmware Installation PDF  -> ftp://ftp.sangoma.com/WINDOWS/AFT/FirmwareUpgrade.pdf

The Driver supports the following models of Sangoma cards: 

• AFT A108 8 Port T1/E1 Board (with optional HW Echo Canceler)
• AFT A104 4 Port T1/E1 Board (with optional HW Echo Canceler)
• AFT A102 2 Port T1/E1 Board (with optional HW Echo Canceler)
• AFT A101 1 Port T1/E1 Board (with optional HW Echo Canceler)
• AFT A200 Analog FXO/FXS (with optional HW Echo Canceler)
• AFT A400 Analog FXO/FXS (with optional HW Echo Canceler)
• AFT A500 BRI Board (with optional HW Echo Canceler)
• AFT A142 Synchronous Dual Serial Card
• AFT A144 Synchronous Quad Serial Card
• AFT A56 DDS

The Sangoma Windows Device Driver contains support for the following applications:

1. WAN IP Networking
2. Libsangoma (api)
3. ADSL - S518

WAN IP Networking

-> Frame Relay, PPP, CHDLC
-> Used to connect to WAN IP networks over T1/E1 lines.

The detailed instructions on how to install and configure Sangoma Windows Device Driver for WAN IP Networking can be found here:"install.pdf".

The Driver operation & debugging is described here: Operation

ADSL - S518

For a single S518 please use our ADSL_V4 driver which can be found at ftp://ftp.sangoma.com/WINDOWS/ADSL_V4.zip.

For multiple S518 cards use our driver at ftp://ftp.sangoma.com/WINDOWS/AFT