Asterisk Configuration

1. Wanpipe LINUX Configuration wizard for Asterisk
   ---
2. Command line configuration for Asterisk (Recommended when using external GUI). 
   ---
3. Wanpipe Legacy Asterisk Configuration
   ---
4. Wanpipe Decoded Configuration Options

Wanpipe LINUX Configuration wizard for Asterisk / Zaptel /Dahdi
     
The wancfg_zaptel & wancfg_dahdi are utilities able to create full wanpipe config, zaptel/dahdi config and zapata/chan_dadhi config files. This utility will work for ALL Sangoma cards: A101/2/2d/4/4d/8d/200/400. For T1/E1 port wancfg_zaptel/wancfg_dahdi will ask few questions relating to front end configuration.  For Analog cards there are no questions asked configration is automatic. 
[Trixbox users Click Here ]

1. For Wanpipe/Dahdi/Asterisk Run:
   /usr/sbin/wancfg_dahdi 
   
   Based on your selections wancfg_dahdi configurator will create:
       1. /etc/wanpipe/ config files
       2. /etc/dahdi/system.conf files
       3. Optionally /etc/asterisk/chan_dahdi.conf files.
   ----
2. For Wanpipe/Zaptel/Asterisk Run:
   /usr/sbin/wancfg_zaptel  
   
   Based on your selections wancfg_zaptel configurator will create:
       1. /etc/wanpipe/ config files
       2. /etc/zapte.conf files
       3. Optionally /etc/asterisk/zapata.conf files. 
   ---
3. Once wancfg_zaptel/wancfg_dadhi is finished your environment will be fully configured and setup to work with asterisk.
   --
4. Proceed to write your dial plan based on
   /etc/dadhi/system.conf and /etc/asterisk/chan_dahdi.conf   (For DAHDI)
   or
   /etc/zaptel.conf &  /etc/asterisk/zapata.conf  (For Zaptel)
   
   --
5. End of Wanpipe/Zaptel/Dahdi configuration  
   --
6. To start wanpipe & asterisk run:
   
   1. wanrouter start             #starts all configured wanpipe ports 
   2. ztcfg  or dahdi_cfg        #configures zaptel/dahdi (usually done by above wanrouter start)
   3. safe_asterisk                #starts asterisk

Top