WAN- Configuration

Sangoma AFT cards Wanpipe Configuration

Run wanpipe configuration utility:

/usr/sbin/wancfg

Hardware Setup (AFT):

Select Hardware: Specify which AFT card installed from hardware probe.

    After probing the hardware, wancfg screen should show  you:
    (in this example, an A101 card)
    ----------------------------
    Card Type-------> A101    
    Physical Medium-> T1    
    ----------------------------

       Sepecify Line Type:  T1 or E1
                                 Default is T1 

Select Advanced Physical Medium Configuration:

       Specify Line decoding, Framing, TE clock mode, etc 

Select Advanced Timeslot Groups Configuration

       Number of Timeslot Groups  ------> 1 (number of interfaces)

            For example:  choose 2 interfaces ( 1 ---- 1-12 channels & 2 ---- 13-24 channels )

                   Select Tiemslot Group 1 configuration  and put 1-12 there instead of ALL 

                   Select Tiemslot Group 2 configuration  and put 13-24 there instead of ALL    

Default configuration is complete: Select <BACK>

Protocol Setup:

Select Protocol: PPP / HDCL Streaming / CHDLC / Frame Relay / ATM

Go back and configure selected protocol

         Take ATM as an example, you need to specify ATM encapsulation mode, VPI and VCI

Configuration is complete: Select <BACK>

Interface Setup:

By Default, Operation Mode is WANPIPE

Select: IP Address Setup

        IP Info:     Local   =201.1.1.1
                        PtoP    =201.1.1.2
                        Netmask =255.255.255.0
                        Gateway =201.1.1.2 (i.e. this is the system
                                                 default gateway)

If you have more than 1 interfaces, you need to configure them respectively.

Configuration is complete: Select <BACK> to Save and Exit

 

Proceed to Operation section