- Sangoma Software
- Hardware Products
- Hardware Annoucements
- Digital Voice and Data
- Analog Telephony
- Digital Analog Hybrids
- B700 Flex-BRI
- B601 T1/E1/J1 + 4 FXO + 1 FXS
- T3Mux M13 Multiplexer
- Vega Appliance Series
- Sangoma Media Transcoding
- Voicetime USB Sync
- USB FXO (U100)
- T1/E1 Tapping Solution
- Data Cards
- Fax Sync Solution
- Cable Pinouts
- Product Installation Manuals
- Hardware Production Test
- Tutorials
- Asterisk®
- FreeSWITCH
- Netborder SS7 to VoIP
- Netborder Call Analyzer
- NetBorder Express
- Vega Appliances
- Sangoma Media Transcoding
- Yate
- CallWeaver
- Legacy & End of Life
- Technical Support
- Wiki Blog
B700 Flex-BRI
|
|
Introduction
- Connect up to 4 ports of BRI plus 2 ports of Analog FXO or FXS
- 4 ports of BRI are supported. Mix TE and NT modes, as required. Changing modes requires no jumpers—simply invert the colour-coded module
- Supports Asterisk®, FreeSwitch™as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications
- uses Wanpipe Driver which includes a suite of configuration, operation and debugging utilities
Wanpipe Driver Download
------
-> Linux: Wanpipe Driver
-> Windows: Wanpipe Driver
Installation and Configuration
Linux: -> Asterisk
-> FreeSWITCH
-> API support: Voice API, Wan IP, Multi-Link PPP, HDLC, X25
-> Netborder
* Note: BRI is now supported in DAHDI. Wanpipe Driver 3.5.21 and up required for BRI installation with DAHDI
Deprecated smg installation (wanpipe 3.5.20 and below) found HERE
Windows: -> Installation: Netborder
Configuration
Hardware Configuration
When using FXS modules, an internal 12V power to A200 main board is required. Use 4-pin Molex power connector from server power supply
B700 BRI Termination resistors to switch between NT and TE modes
The B700 comes with termination resistors that have to be disabled (set to OFF) when running in TE mode and enabled (set to ON) when running in NT mode.
The resistors corresponding ports 1 and 2 are closest to the PCI base.
The ON position is closer to the NT/TE modules.
The OFF position is closer to the RJ-45 connectors.
FXO/FXS Module Installation
Slide the module into the main card until they click in properly. You should be able to read the designation FXO or FXS on the outside of the card (Remora) after installation.
FXO modules are RED in color
FXS modules are GREEN in color
FXO/FXS Modules have RED/GREEN face and BLUE back. The analog port will glow RED (if FXO module) or GREEN (if FXS module) depending on which type of modules is installed.
How to Connection PSTN lines to A500:
Pinouts
Analog: There are two lines in the RJ11 connector. The first line is on the inner pair and the second line is on the outer pair. See the diagram below for detiails
-> Y straight thru Cable
-> Straight Thru Cable
-> BRI loop-back plug
-> Analog Cable
-> Analog Loop-back plug
Firmware Update
-> Linux: Firmware update
-> Windows: Firmware Update
